Operation Manual Blanket-Lite 6x6 DMX Part No. 3100
10 Four Mega 4Bank DMX Ballasts are required to operate one Blanket-Lite fixture. Set the unit to “Individual Lamp” mode and jumper
11 A) Circular Output Connector: Provides electrical power to the lamp head with the use of a 4Bank extension cable. B) DMX-In &
12 The DMX Terminate Switch must be set to open ( O ) on Ballasts within the DMX chain. Set to closed ( I
13 Any theatrical lighting board with DMX 512 protocol can be used to individually turn on/off lamps in a Fixture. Mega DMX 4Bank Ballasts can be
14 Setting the Ballasts to "Fixture Mode" allows the user to turn lamps on and off with an “inside-out” pattern from a dimmer board. For
15 1 2 4 3 9 8 6 7 11 12 14 13 19 18 16 17 Lamp Address Ballast 1Ballast 2Ballast 3Ballast 4Lamp Select FeatureThe Mega 4Bank DMX Ballasts have a HO
16 WARNING! 1) ALWAYS TURN OFF THE BALLAST BEFORE connecting or disconnecting Lamps, Harnesses or Extension Cables. 2) Use only with Sine wave
17 XLR-503 Dmx Cable 5-Pin xlr, 3ft DFS-6X6-G Full Grid Cloth Diffuser MTP-BKT-100 Fra
18 KAS-6X6 KAS-6X6-F KAS-4MX BLANKET-LITE Specifications:Outside
19 Environmental: Disposal of Old Electrical & Electronic Equipment. Kino Flo, Inc. 2840 N. Hollywood Way
2 BKT-6X6 Blanket-Lite 6X6 KAS-6X6 Blanket-Lite Case BAL-450-M120 BAL-450-M230 Mega 4Bank Dmx Ballast (x4) X19-
3 The Frame Assembly (FRM-6X6) consists of: 4 Frame Corners 4 Frame Pipes 12 Frame Clip Pins 2 Frame
4 The Blanket-Lite should travel with lamps preloaded. 1) It is recommended to mount the frame between t
5 6) Draw up any slack in the strap and tighten by drawing down the ratchet lever until tight. Use the Harness Velcro straps to secure the
6 To give rigidity to the Blanket-Lite insert 4 pins through the pipe frame into the two horizontal Blanke
7 Apply the silver cloth reflector (REF-6X6) by looping the elastic corner ties around each corner. Or
8 Each corner of the Louver (LVC-6X6 sold separately) has an adjustable Velcro loop. Loosely hang the tw
9 Using the Mafer Clamp (MTP-AME58) mount the Hanger onto the stand. Slide the Tray onto the Hanger.
Comments to this Manuals